What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 02.07.2025 08:14
These devices are installed between the “hot” and “neutral” and protective ground.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
Vice President JD Vance Just Delivered Incredible News to Bitcoin Investors - Yahoo Finance
He then asserts :
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
Raw recap & reactions: Royal chaos - Cageside Seats
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
what exactly is a ‘surge’ protector?
How can you know if they are your twin flame and not limerence or obsession?
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
There are two important concepts here.
So, the voltage could go up to 500 volts, and the fuse will not open up.
New Duck Kreider Discusses the Trade to Anaheim - NHL.com
One is “what exactly is in a ‘surge protector’ ? ”
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
A circuit breaker is similar, but is resettable.
(Dc diagram shown, AC is similar).
He then describes Rainy Season and Lightning.
Coco Gauff tops Aryna Sabalenka to give the French Open an American champion - The Washington Post
The other is “what does a “fuse” do?”
but this device (an Inductor) … impedes the rapid changes in the current.
What is lightning?
Do you think Trump is a bad a$$? Why or why not?
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
What does a fuse do?
[old diagram got deleted by accident]
so, what happens?
How to Watch Tonight's NBA Finals Indiana Pacers vs. Oklahoma City Thunder Game 1 for Free - CNET
There are three different concepts here that are getting confused.
An AC voltage/ current source, and an ac inductive load.
In schematic diagrams this is the symbol for a fuse:
Meta – yep, Facebook Meta – is now a defense contractor - theregister.com
a photo is worth a thousand words.
The third is lightning and “how it gets conducted into a home.”
First Sentence:
Here’s where to get free doughnuts on National Donut Day 2025 - Fortune
Because the load is inductive, the current lags the voltage.(by a bit).
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Now when you have a certain ac resistance, then a current flows in a loop.
The bolt then partially travels down the line to your home.
At one ohm, the resistor has a maximum of 1 watt power.
the problem then depends on "how fast does the fuse operate?".
But it can get overloaded, and no longer works.
[image of Common-mode choke]
Edit 2024–10.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Here is a simplified AC power diagram.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Barnstars:
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
2024–10–16 [ OO OLAOYE OYEBODE ]
At least they know the answer if they wanted it.
The MOV will conduct when the voltage exceeds 50% of line voltage.
but I think this circuit , shows a few more pieces.
eight
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
2024–10–14 [Omar Gharbi Omar Gharbi ]
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
This is 'the assistant's answer'
One
This is where this question deviates from being a 'generic' question, and becomes more specific.
Upvotes:
It seems Mohan does not understand the difference between a comment and an Answer.
2024–10–10[John johnson John Johnson ]
A fuse is a non-resetable over current circuit protector.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
This device then solves the entire problem.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
It also is a device that limits the change in current flow.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
This is the picture of an electronic coil of wire wound around a core of magnetic material.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
For this case there are devices called Metal oxide varistors (MOV).
He then describes the function of a fuse.
I post the exact comment here.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
This one hit behind the barn.
This is where the MOV conducts again, and dissipated the energy.
But… the neutral is now “floating” because of the 1 ohm resistance.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
nine
These are simplified answers to the original question, and does not change anything I wrote above.